Search results

Re: Will not start if by ignition control module then yes brand new

Re: Will not start doesn't make a difference if its to the floor or not

Re: Will not start Rechecked the fp and had power the whole time when cranking. going to try the injector test I got the test kit. Still starts right up with ether and runs great after but wont start on its own. has about 47 psi cranking fp pump has power based on test lead ignition module is...

Re: Will not start Thanks for the great info. I tested the lead using a test light between the lead and a hot positive (not sure if this is the correct procedure) and it has power (light lit) but with key to start and engine cranking the light goes out, a few seconds after I stop the light...

Re: Will not start I did forget to disconnect the vac line would that make a big difference?

Re: Will not start did filter and rechecked the pressure goes to 45 psi to prime and almost 50 psi (mostly 47psi) on cranking. Reset spun oil gauge but that just keeps flipping so that is something else.

Re: Will not start hey sorry been crazy busy with work the past few days. oil pressure has always been fine course right now suffering from the spun gauge and haven't gotten time to do that or investigate things further was just reading how the oil pressure switch can be a problem. Fuel is...

Re: Will not start Starts right up with it and runs fine

Re: Will not start been searching more would the oil pressure switch be something to consider? How would I test if that is the problem. I'm beyond stumped with this one.

Re: Will not start as soon as I turned the key yes

Re: Will not start got the gauge and pressure went right up so another possibility eliminated. Went to the ether again and it fired right up so I drove around a bit ran great no problems or hesitation. Parked it waited a couple of minutes tried to restart a few tried nothing and then pumped gas...

Re: Netbook For Sale pm sent tentative dibs

Re: Will not start picked up the pressure and injector tester at harbor freight love the 20% coupons. See what they show. What cranking pressure should I look for?

Re: Will not start Its driving me nuts I'm trying :rotf: Is there a decent fairly inexpensive tester? would a extra gauge work? really hoping its not the pump. I assume it needs, I think I read 45 psi on start. Is that maintained while driving? It ran fine once it started just won't get there.

Re: Will not start I have to get a pressure tester (everyone I find is like $75) but would it run fine as it did when it started with starting fluid with poor pressure? Thanks, its driving me crazy nothing looked fouled wires, plugs, cap and rotor are not that old and the ones I pulled...

Re: Will not start tried switching relays and no difference even tried a new one that I know works I attached a wire the test pigtail with a test light on it. It lit up and when I engaged the starter it would go off. after a few cranks I stopped and I would hear a faint click near the...

Re: Will not start Was also thinking coil it's msd but the puzzling part is it ran great after started with the starting fluid. Hoping someone has an idea

Re: Will not start Going over wires and everything looked good. Decided to try ether. Popped a few times pumped gas and it fired up ran rough for a few seconds, settled down and everything ran fine. After letting it run a while shut it down. Tried to restart without ether. popped a few times...

Re: Will not start Mostly stock computer has 59 and a2a. Thanks for the top Jimmy made perfect sense to think module.

Re: Will not start fuses all look good can't find any split wires or loose connections. check engine and gauges light comes on when turn key and the gauges one flashes when cranking