X-cab Sy
- Thread starter fauXGT
- Start date
Chest Rockwell
Active member
Re: X-cab Sy
Thanks for the virtual tour, Chip. Such a cool project.
Thanks for the virtual tour, Chip. Such a cool project.
warmpancakes
New member
Re: X-cab Sy
Love the bravada specific seats that some people dont think exist, what alpine is that in the dash? what meaterials did you use to bond the cladding?
Love the bravada specific seats that some people dont think exist, what alpine is that in the dash? what meaterials did you use to bond the cladding?
Number219GT
Broke Status
Re: X-cab Sy
Nice job! Im really feeling it, cant wait to see it finished.
Nice job! Im really feeling it, cant wait to see it finished.
fauXGT
Brick Pilot
fauXGT
Brick Pilot
Re: X-cab Sy
Thanks to all for the compliments.
The joints and repairs are melted with a plastic welder kit.
Urathane Supply Co. sell it. I got it a year ago for alot cheaper than it is now! Melt wire mesh half way into the cladding. Use small broken cladding pieces to fill in and slightly overfill. Sand down to flush. The plastic rods that come w/ the kit don't sand & blend very well with the cladding, but can be used on back side for extra support.The Ty rocker has a slight arch in lower drop off, while the Sy rocker is more square. Used bondo to blend the two pieces. On some seams, I melted a layer of mesh from front and from rear to make very rigid.
Hope to take her to Nats next summer and meet the gang. The green SoGT won't even be close to being done, but working on finishing the shop now so it'll be inside for the winter. Probably has been outside most of it's life.
Oh, the Alpine is mod# 7914. Amps are in the glove box W/ a small fan in access port in back for cooling. Been in the truck since '92.
Thanks to Steve a.k.a. Chest Rockwell for the door panels. A nice and cheap grab.
Thanks to all for the compliments.
The joints and repairs are melted with a plastic welder kit.
Urathane Supply Co. sell it. I got it a year ago for alot cheaper than it is now! Melt wire mesh half way into the cladding. Use small broken cladding pieces to fill in and slightly overfill. Sand down to flush. The plastic rods that come w/ the kit don't sand & blend very well with the cladding, but can be used on back side for extra support.The Ty rocker has a slight arch in lower drop off, while the Sy rocker is more square. Used bondo to blend the two pieces. On some seams, I melted a layer of mesh from front and from rear to make very rigid.
Hope to take her to Nats next summer and meet the gang. The green SoGT won't even be close to being done, but working on finishing the shop now so it'll be inside for the winter. Probably has been outside most of it's life.
Oh, the Alpine is mod# 7914. Amps are in the glove box W/ a small fan in access port in back for cooling. Been in the truck since '92.
Thanks to Steve a.k.a. Chest Rockwell for the door panels. A nice and cheap grab.
warmpancakes
New member
fauXGT
Brick Pilot
92TYPHOON937
Active member
Re: X-cab Sy
nice truck
nice truck
