Search results

Well at the time I did Accell I think that's what everyone was using and now I am done with Accell :) I was planning on doing the top end cleaner but am pissed because I just replaced the oil and filter and would need to change it again (Mobil 1 fully synth doesn't come cheap). On the pos...

Currently stock with AC plugs, Accell wires, and Accel Cap'n Rotor. I will be doing the following: Top Dead Center Conrad DR2012G Taylor Wires (TAY-74632) NGK UR6IX plugs Vacuum Line replacement maybe PCV valves (starter just replaced with 10 gauge wire heat shield and wrap) Gauges - Boost...

I have the circuit system and probable causes for the codes. I can't check anything right now. The black smoke though is rich fuel and I am suspecting that since I haven't had a tune-up in 1.5-2 years that a plug or two is bad or a wire. I did check and made sure no wires were loose. What's...

Hello sytyers, The Ty has been running great....until this morning. I went to start her up and it took forever. She was hesitating, RPM's all over, surging, then eventual death. She would start up and run eventually though (with these conditions except cutting out completely). With this she...