Recent content by paulp

Does anyone know where to buy a new throttle cable mine sticks at wide open throttle not good.

I currently have 412 cam, 850 lifters, 1.5 roller tip rockers and stock length push rods, on L-35 heads. The lifters are noisy and I think I'm getting false knock in park at 2000 rpm from 3-10 deg. All parts are new and lifters and rockers have been changed with another set of new ones. The only...

Re: False Knock block stock 4.3 .030 eagle rods CRS570063D pistons TRW-L2441F30 cam 09-412-8 (comp cams) oil pump M-55HV double roller timing change KB under drive pulleys machine shop assembled, balanced and set cam to cam spec's heads L-35 2.02 intake and 1.60 exhaust extreme duty RPM...

Can anyone tell me how to figure out if I have false knock? With a scan tool hooked up I get about 3 to 4 degrees at 2000 truck in park, and when I rev it it goes up to 10. I found out that knock retard won't start till around 1800 so I can't read it at idle. Turned fuel pressure up to 60 no...

can anyone help? valve train sounds like a sewing machine. Here is what I have done so far, adj lifters cold, hot and running (cut out valve cover) each time 1/4, 1/2 and 3/4 turns no luck. Stock car racer said try turning them down running till the engine starts to miss and back them off 1 turn...

Can anyone help with this problem? Here is a little history, I had the engine rebuilt last fall and it hasn't run right sense. During the rebuild I had a lot of up grades. Here is a list..machine shop did the short block work and assembly, stock 4.3 .030 , eagle rods CRS570063D, pistons...

Re: can anyone help? Thanks for the reply, Here is what I have done so far, adj lifters cold, hot and running (cut out valve cover) each time 1/4, 1/2 and 3/4 turns no luck. Stock car racer said try turning them down running till the engine starts to miss and back them off 1 turn still no luck...

Can you help with this problem? Here is a little history, I had the engine rebuilt last fall and it hasn't run right sense. During the rebuild I had a lot of up grades. Here is a list..machine shop did the short block work and assembly, stock 4.3 .030 , eagle rods CRS570063D, pistons...

Can you help with this problem? Here is a little history, I had the engine rebuilt last fall and it hasn't run right sense. During the rebuild I had a lot of up grades. Here is a list..machine shop did the short block work and assembly, stock 4.3 .030 , eagle rods CRS570063D, pistons...