Need a few bolts

[wildphil]

I am missing a few bolts and thought maybe someone may have some lying around that I could purchase.

The bolts used to secure the transmission to the back of the engine block.

I think 3 of the bolts for the A/C bracket to engine block.

I am missing a few of the bolts that fasten the motor mount to the engine.

I am also missing 2 or 3 of the bolts and nuts the secure the motor mount pad to the frame.

Also the long bolts that go through the motor mounts.

That is all I know of at this time. It would be nice if someone has these available. Save me hunting them down at the pull a part.

Thanks in advance.

 

[blue83z]

Re: Need a few bolts

I may have a few of them, but would probably need some pics to match them up. Don't know how much that would help.....cause if you had a pic, you would probably have the bolt.

Post if you have it and is will match up with my Syty box I bolts. If I find it I'll just ship to you.

 

[wildphil]

Re: Need a few bolts

If I am unable to locate any of the bolts that I have a few of I will post pictures. That may help you match up with some you have. Thanks for the post.

The Syclone that I picked up the engine was taken out and disassembled. And a lot of the fasteners are missing.

 

[Damian]

Re: Need a few bolts

I might go to the junkyard Monday, maybe I can find all of those for you. PM me if you would like me to look for them. I don't come to the wanted forum much to be honest.

 

[Sportmachines]

Re: Need a few bolts

We have all those. Should be able to sort, separate and box em up for you this week sometime.

 

[wildphil]

Re: Need a few bolts

I updated my first post. I came up with exhaust manifold bolts and most for the A/C bracket.

 

[SY2932]

Re: Need a few bolts

I can help out with the bolts that hold the transmission to the engine... There are six bolts total all being 3/8" X 16 TPI. Five being 1.5 inches long and one being 4.5 inches long (driver's side bolt that holds the transfer case brace in place)... HTH's.

Just checked one of two engines that I have on engine stands... The bolts that hold the engine mounts to the block are also 3/8" X 16 TPI 7/8 of an inch long times three per side, six total.

 

[GarnetTy1473]

Re: Need a few bolts

Getting ready to leave work for the day, so only had time to look up the bellhousing bolts, but they show to still be available from GM. I'll try to look up the rest tomorrow and see what's available.

 

[wildphil]

Re: Need a few bolts

Thank you guys.

And thank you for giving me the bolt sizes Mike. I can pick those up at the hardware store.

 

[SY2932]

Re: Need a few bolts

Thank you guys.

And thank you for giving me the bolt sizes Mike. I can pick those up at the hardware store.

Just a word of caution on the bolts that hold the motor mount plate to the side of the engine. Those bolts have a thick washer that is close to 1/8 of an inch thick. If you don't use a washer, you may want to use a bolt 3/4 of an inch long so you don't risk bottoming out the bolt in the hole.

No problem on the bolt sizes. Frankly with as many people that have engines out, I'm surprised you didn't get this info sooner :squint:.