PPI Typhoon
DIY Madman
Ok, well in my LSx swap, I'm realizing that my T76 is not going to work for my application, so it's time to let it go to a good home.
It's a Garrett T76 GTQ
Ball bearing center section
Water cooled
PTE exhaust housing (.85 a/r 3" outlet)
Polished compressor (some scratches....could be rebuffed for best look)
If memory serves me correctly, the exhaust housing was ceramic coated by Nolan
Wastegate port has been enlarged as well by Nolan.
Shaft play is nothing, still runs very smoothly as you can see from the video below.
As mentioned above, there are minor scratches on the compressor cover which can be taken care of with rebuffing the whole cover. I just didn't have time to do this. The blades are great, was used with a filter, so no sandblasted blades or anything like that.
I purchased this from Nolan for over $1000 a couple years ago and once I put it on the truck, the truck saw less than 650 miles. If I'm not mistaken, he had it on his truck and it went 10's. The spool time is very nice, even when I was running it on the stock converter. It comes with the T3 adapter flange that spaces it out enough to still use your A/C
I'm asking $900 obo plus shipping to the lower 48.
YouTube video showing smooth bearings and no shaft play:
http://www.youtube.com/watch?v=ngx23YvJIrs
here are some pics for reference. I'll take more pics tomorrow when it's light out.
I can accept paypal or a cashier's check. It will ship nicely packed and insured.
It's a Garrett T76 GTQ
Ball bearing center section
Water cooled
PTE exhaust housing (.85 a/r 3" outlet)
Polished compressor (some scratches....could be rebuffed for best look)
If memory serves me correctly, the exhaust housing was ceramic coated by Nolan
Wastegate port has been enlarged as well by Nolan.
Shaft play is nothing, still runs very smoothly as you can see from the video below.
As mentioned above, there are minor scratches on the compressor cover which can be taken care of with rebuffing the whole cover. I just didn't have time to do this. The blades are great, was used with a filter, so no sandblasted blades or anything like that.
I purchased this from Nolan for over $1000 a couple years ago and once I put it on the truck, the truck saw less than 650 miles. If I'm not mistaken, he had it on his truck and it went 10's. The spool time is very nice, even when I was running it on the stock converter. It comes with the T3 adapter flange that spaces it out enough to still use your A/C
I'm asking $900 obo plus shipping to the lower 48.
YouTube video showing smooth bearings and no shaft play:
http://www.youtube.com/watch?v=ngx23YvJIrs
here are some pics for reference. I'll take more pics tomorrow when it's light out.
I can accept paypal or a cashier's check. It will ship nicely packed and insured.
Last edited:
