Cunningham rods torque specs

[SyTyAddict]

I'm looking for the torque specs for cunningham rods (4340, 6", I-beam). I am going to check the clearances while the diff is out, but would like to get the specs before pulling the caps. Also, if anyone has any information for the optimal clearance range I should look for, it would be appreciated also.

 

[THEMADTYPH00N]

Re: Cunningham rods torque specs

Depends on the fastner thats in the rod. Lots of the high rods will give you rod bolt strech rather than TQ as well.

 

[SyTyAddict]

Re: Cunningham rods torque specs

The cap screws just say "Cunningham rods," they look like arp 12 point cap screws that I see on other aftermarket rods. I'll probably just call them tomorrow if I don't find anything out. I know there are a handful of people on here running them, I was hoping someone would know.

Thanks