Search results

Looks like Sportsmashines is the new owner.

When I go with stock type suspension parts. Moog is what I always use. They have always been good quality and last for a long time on the vehicles I have used them on.

After seeing the prices they are bringing. I only wish that I still had more trucks to sell.

I haven't been interested enough to read the comments. I cannot believe the prices some of the trucks have been selling for. Very high.

WOW!!! I have never seen anything like that before.

Interesting.

Listen to Dave about the slipped ring on the balancer. I had it happen on two of the three SyTy that I have owned. It happens very often and will screw up trying to get the timing set for sure.

I think you just made his point.

I sure wish that I would have sold my trucks through BAT. WOW!

I think this is the muffler that you are looking for https://www.summitracing.com/parts/wlk-17733

Well if the fluid smelled burnt it will probably not be going much longer. Is it slipping in 2nd gear? Like the vehicle not moving faster when the throttle pedal is pushed down, only higher engine rpm? Yeah if that is the case. It is time to rebuild for sure.

Ei :) Make sure the downpipe flange surface fits flat against the turbo, it should. At least I have never seen a gasket for that location.

If the fluid doesn't smell burnt and if there are no chunks in the pan. I would change the fluid and filter and drive it if it were mine.

I think that I just used a can of black Rustoleum paint that I had. It would probably be better to use a paint that is made for a plastic surface but what I used lasted for years and was still going strong.

You could do it. It is really no problem to do at all. Just tape off the part of the emblem that you are not painting so you do not sand it. The lightly sand the red part. It is plastic so you only have to hit the surface with a few sanding strokes maybe 3 or 4. Then I take that tape off, wash...

It has been several years since the black letters could be purchased new. Probably the only way to get them would be take off items. The last set that I had I ended up making. I ordered a new repo red set from LMC. Scuffed the red with 400 grit sandpaper and painted black. They turned out very...

That is probably good enough. If not I bet someone will post to let us know.

If I recall the rod was adjusted about right. If you adjusted the rod so that it is even with the stud I do not believe that is correct. I would have to see if I can find the correct amount by searching now. It changed once after the original suggested setting. I think in the beginning it was...

Do you know how to check for diagnostic trouble codes? Here is a video that shows how to do it if you do not know. You can use a paperclip or piece of wire to get the codes. This guy tells you that you will get a code 12 for 3 times to start. That would be the check engine light flashing one...

If you leave the transmission in D or OD and accelerate at maximum rate. Does the engine loose power like that also or only when manually shifting? I am wondering if your truck is over-boosting under hard acceleration. It will loose power just like the key in the ignition was switched off until...