JKsSyclone
Active member
Re: What are your least-favorite SyTy Tasks?
Filling the gas tank. :dunno:
Filling the gas tank. :dunno:
What are your least-favorite SyTy Tasks?
- Thread starter DaveP
- Start date
TNPhoon
1of28
Re: What are your least-favorite SyTy Tasks?
I have an extra dashmat if you're interested and happen to be going to Kellers this year or will be up in Nashville anytime soon. It's not embroidered with the Ty logo though.
I have an extra dashmat if you're interested and happen to be going to Kellers this year or will be up in Nashville anytime soon. It's not embroidered with the Ty logo though.
fivetodrive
CRISPY
Re: What are your least-favorite SyTy Tasks?
Getting the burnt smell out of Crispy... and some things that have been left out
Manifold replacement (500 degree oven trick works pretty well)
Tightening the distributor bolt after setting the timing, (without a 1/4 drive socket and swivel)
Tightening the upper left turbo nut on a PTE housing
Getting the burnt smell out of Crispy... and some things that have been left out
Manifold replacement (500 degree oven trick works pretty well)
Tightening the distributor bolt after setting the timing, (without a 1/4 drive socket and swivel)
Tightening the upper left turbo nut on a PTE housing
jeepruby04
New member
blacktyaffair
Donating Member
Re: What are your least-favorite SyTy Tasks?
Ty gas tank wasn't any more difficult than any other gas tank I have had to drop.
Stock rubber motor mount removal was more of a chore than than installing the solid mounts/frame pads.
From diff R/R was a pain.
Tuning is difficult for me right now, but I'm sure it'll get easier the more time I spend with it.
Least favorite syty task for me would have to be KR troubleshooting.:tdown:
Ty gas tank wasn't any more difficult than any other gas tank I have had to drop.
Stock rubber motor mount removal was more of a chore than than installing the solid mounts/frame pads.
From diff R/R was a pain.
Tuning is difficult for me right now, but I'm sure it'll get easier the more time I spend with it.
Least favorite syty task for me would have to be KR troubleshooting.:tdown:
5678TA
New member
Re: What are your least-favorite SyTy Tasks?
X2. the fact that the cat wouldnt come off made it even more fun! ended up cutting it in half.
X2. the fact that the cat wouldnt come off made it even more fun! ended up cutting it in half.
the baPhoon
Active member
Re: What are your least-favorite SyTy Tasks?
Fuel pump.
Fuel pump.
TrboSy2051
New member
Re: What are your least-favorite SyTy Tasks?
Trying to find a used tailgate in AK (still haven't), front control arm bushings, heater core and getting rid of the overnight ant infestation while it was my dd.
Trying to find a used tailgate in AK (still haven't), front control arm bushings, heater core and getting rid of the overnight ant infestation while it was my dd.
dalwine250
Donating Member
Re: What are your least-favorite SyTy Tasks?
prepping cladding for paint sux and ive done many.trans r&r sux too.fuel tank and heater core i didnt think was too bad .to be ,putting it up on jackstands is by far the worst.you know it likes it and will be there for a while
prepping cladding for paint sux and ive done many.trans r&r sux too.fuel tank and heater core i didnt think was too bad .to be ,putting it up on jackstands is by far the worst.you know it likes it and will be there for a while
The Bronze
New member
Mtn Z
Donating Member
Re: What are your least-favorite SyTy Tasks?
Solid motor mounts and front diff with engine in. My passenger side rubber engine mount was smashed so bad that I had to use a ratchet strap to rip it off. That sucked.
I can't wait until I have to start tackling all the other little leaks that are pretty much everywhere.
Solid motor mounts and front diff with engine in. My passenger side rubber engine mount was smashed so bad that I had to use a ratchet strap to rip it off. That sucked.
I can't wait until I have to start tackling all the other little leaks that are pretty much everywhere.