WB02 for FAST Install

[protosy]

Quick question...

I am currently trying to install my FAST ECM with PTE adapter harness in my sy. i have the WB02 option and i am trying to figure out how in the heck to wire it up.

the o2 sensor has five wires, the pte harness has 7. the red and orange would appear to be extras on the pte harness. anybody have a clue what to do with that, i know i sure dont.

also, anyone have a quick sheet on how to make those stupid ends for the packard connectors? i have 0 expertise in doing it.

chad

 

[prosty]

Isn't one - and one + ?? I've mounted FAST a few months ago.. I can't really remember that though..

 

[TurboTony]

The two extra wires are for a calibrating resistor within the sensor connector.

What problems are you haveing with the packard connector?

Tony

 

[protosy]

So do I just put the red and orange in the connector in either of the two remaining positions in the connector then?

as for problems.. should I solder them? Or just crimp them? And exactly what tangs should I be crimping. It would appear there is a large set of teeth that I would guess digs into the sheething, then another set of two teeth that look like they dig into the wire itself. is this correct?

thanks guys
chad