Tunerpro / G1 Help

N

NZTY

New member
The problem I'm having is that my ALDL cable works perfectly when the G1 adaptor is not connected however when it is connected I can't seem to get it to connect to the PCM with either Datamaster or Tunerpro.

Any ideas?

Thanks
Anthony
 
SBNova

SBNova

New member
Re: Tunerpro / G1 Help

What chip are you putting in thte G1 adapter? Whatever chip you put in there, it has to be programmed first. I dont know if you know that, just stating the obvious. If your ecm doesnt see a chip- if will be in limp mode with no communication. A blank chip, or an incorrectly installed chip will read the same as no chip.
 
N

NZTY

New member
Re: Tunerpro / G1 Help

I'm using Ostrich which seems to be connecting just fine, bin is uploading to Ostrich. Does the Ostrich need to be programmed also? In Tunerpro the test for valid ALDL cable says the cable is valid. The stock memcal seems to be connected correctly also.

Thanks again
Anthony
 
JSM

JSM

Active member
Re: Tunerpro / G1 Help

i suspect you have something plugged in wrong/backwards, the wrong bin loaded, wrong setting on tunerpro which is forcing the bin to load wrong, something.
 
N

NZTY

New member
Re: Tunerpro / G1 Help

I finally got it all sorted. I changed the batteries in the Ostrich and which seems to have been the problem. Thanks a lot for your help and I will probably have some more questions once I get further along in tuning my truck.

Anthony
 
You must log in or register to reply here.
Top