Re: Tuned port S10 Blazer for sale
Re: Tuned port S10 Blazer for sale
95xtreme said:
ahhhhhhhhhhh, you sell stuff I like. Does it run?, any rust? hows the interior?
Dime size rust spot on the quarter panel. It came from florida. Roof rack was filled in with weld as far as I know. The rear glass hinge area was starting to rust some so at the same time a new panel was put in there. That paint doesnt match but the paint is a little faded anyways. The repairs look pretty good far as I can tell. Nothing a small amount of paint and a buffer couldnt handle.
Interior is blue, vinyl seats but they arent torn up. Manual windows and locks. Stock radio, I think it has aftermarket 6x9's but Im not for sure. Needs cleaned, a headliner, a glove box door and itd be set. If poorboy doesnt want it you could take that gray dash I have from my garage in Illinois on your way back through.
It runs but has no O2 which I assume is the reason it sputters and only goes 30. It drove fine when I bought it and made the hour drive home with the carbureted setup. I drove it about 3 miles across town as is when we moved, I wouldnt recommend anything other than backroads at the moment with it. But we wouldnt have to push this one onto a trailer.
Not sure if I mentioned in the build up thread, but I also have the speedo gear which should make the speedometer right(new from TCI) and I put on the VSS from JTR so it will have that input into the ecm.
Im pretty sure I listed all the mods but one more time off the top of my head....
Brand new walbro pump with 5 miles on it
hedmann shortys
dual flowmasters(I think 40 series, it shakes my house)
corvette radiator
custom harness(with AC, without emissions)
TCI speedo gear
JTR VSS
Brand new 92 TPI ECM from GM
VATS bypass
new brakes all around
new shocks all around
new tires all around
new rear wheel seals
msd coil
I'll try to grab some more pics here shortly of the interior and the bad spots on the body. Also an updated under hood pic
