Ry368
one mile = 5280 feet
Re: Trans Re-build Help
X2.......TH400 with a brake works ****ing awesome!!!:tup::tup::tup:
Trans Re-build Help
- Thread starter gaugeprower
- Start date
Re: Trans Re-build Help
If you don't count it, isn't it consider countless?
No 700r4 will handle countless boost launches and the only way to go fast in these bricks is to launch them.
If you don't count it, isn't it consider countless?
Re: Trans Re-build Help
I cant go faster than 15mph.......watch the video on the 1st page of this thread
I cant go faster than 15mph.......watch the video on the 1st page of this thread
AutoVation
Member
Re: Trans Re-build Help
I just came across this thread and am in a similar position (my tranny is slipping in 3rd gear at full boost and in general not acting correctly...).
This may be a question for CK but is the billet output shaft the only difference between the CK Performance Stage II and Stage III transmissions?
I just came across this thread and am in a similar position (my tranny is slipping in 3rd gear at full boost and in general not acting correctly...).
This may be a question for CK but is the billet output shaft the only difference between the CK Performance Stage II and Stage III transmissions?
Captain Morgan
Moderated User
Re: Trans Re-build Help
I pointed him to this thread, I know he's read it, not sure why he hasn't replied
I pointed him to this thread, I know he's read it, not sure why he hasn't replied
Re: Trans Re-build Help
Chris do not like online forum because of the bickering and its time consuming, too bad now that king George left the throne.
CK have a few CNC machines which he make a lot of custom parts like output shafts and other thing that he supply to other shops. His price is resonable because he don't have to mark it up.
I remember someone wanting 300m 4l80e output shaft, they should contact Chris.
Chris do not like online forum because of the bickering and its time consuming, too bad now that king George left the throne.
CK have a few CNC machines which he make a lot of custom parts like output shafts and other thing that he supply to other shops. His price is resonable because he don't have to mark it up.
I remember someone wanting 300m 4l80e output shaft, they should contact Chris.
Re: Trans Re-build Help
He was crucified on the GN boards years ago. He has an excellent book on 200's.
You may have to wait awhile on custom CNC stuff from him. He does take a while, but most customstuff does. He's not going to make the 700r4 drum that was talked about a few years ago. George had some interaction with him.
He was crucified on the GN boards years ago. He has an excellent book on 200's.
You may have to wait awhile on custom CNC stuff from him. He does take a while, but most customstuff does. He's not going to make the 700r4 drum that was talked about a few years ago. George had some interaction with him.