Set back plates + ????

ChevelleDude71

ChevelleDude71

Lo Boost
Hey all, first off I did search, but did find what I was looking for.
I have the beltec lowering springs, and a 3 inch block on my sy ( Don't really care about ride quality, I just like it low ) and I hate how the wheel will sit 1.5inches from the front Cladding and 3+ inches from the rear cladding. Tomorrow I will get around to ordering the set back plates, but those are only 1/2 an inch. It looks to me like I will need at least 1in-1.5in to get it centered. So my question is what more can I do to get this wheel centered? Too bad I can't just drill a new hole 1/2 an inch back through the leafs and mount it up there... :roll:
 
mattw

mattw

Active member
Re: Set back plates + ????

There was someone on here that was selling custom lowering blocks that incorporated a 1/2" set back.

I just bought a set of aluminum lowering blocks from autozone, then I welded a filler plate into the bottom of them and drilled a new hole 1/2" back:

05_Blocks%20Complete.JPG


I hate the way the wheels aren't centered in the wheel-wells from the factory.


-Matt
 
C

CKEITH

Doghouse Member
Re: Set back plates + ????

mattw said:
There was someone on here that was selling custom lowering blocks that incorporated a 1/2" set back.

I just bought a set of aluminum lowering blocks from autozone, then I welded a filler plate into the bottom of them and drilled a new hole 1/2" back:

05_Blocks%20Complete.JPG


I hate the way the wheels aren't centered in the wheel-wells from the factory.


-Matt
Click to expand...


jwaller offers the lowering block with the correct offset.

www.wallerperformance.com
 
You must log in or register to reply here.
Top