prop shaft ? again

[Raist103]

Well tomorrow I will get off my ass to put it in but I looked at it for the first time in a while tonight and it is completely different then the one I had in. It is the ATR one for $479.00 one side is round and the other is square. Anyone have this shaft in there SY/TY and if so what side goes on the front and what side goes on the back. Also I am hoping it is the same as taking it out just the four bolts on each side and done. I took advise from the other post I had up and got some hex 10.9 bolts in the sizes that were mentioned and some locktite.

Thanks
Don

 

[ed hess]

round end with rubber insert goes to the front
ed

 

[Raist103]

thanks ed

 

[Loeryder]

Hex heads kinda suck getting in and out.
you get about a 1/8 turn and thats it.

I am looking for the Allen head screws myself.

 

[Raist103]

yes they do but i got them in, just could not torc down to 52lb's since I don't have a torc wrench. I called some places today to get a price for them just to make sure they are tight and they are talking $37-$65 just tol make sure they are tight. ASS's tring to rip me off because I did all the work. Oh well I will recheck after a day or two and see if they are still tight unless I could use someones wrench for a couple of min.s