Syclone0565
CustomMulticades.com
Can someone link me to the roof rack removal thread that has the parts list of the bolts, O-rings, etc. ? I saw it on here but can't seem to find it again 
Thanks
Thanks
Needs some quick help...
- Thread starter Syclone0565
- Start date
Syclone0565
CustomMulticades.com
Re: Needs some quick help...
Finally found it. I don't think I am going that direction after all Oh well.
http://www.syty.net/forums/showthread.php?t=38175&highlight=roof+rack+holes
Finally found it. I don't think I am going that direction after all
Oh well.http://www.syty.net/forums/showthread.php?t=38175&highlight=roof+rack+holes
Syclone0565
CustomMulticades.com
Re: Needs some quick help...
No ! For right now a 10 second Ty will do me fine. For a while...
No !
For right now a 10 second Ty will do me fine. For a while...
eviltwin
"junkyard syclone"
Re: Needs some quick help...
Ummm isnt that what you hit in you LS syclone?
No !
Ummm isnt that what you hit in you LS syclone?
Syclone0565
CustomMulticades.com
Re: Needs some quick help...
Yes. Pulled right off the trailer, very first run down the track. Stock LQ9, 1 PSI launch, like 8 psi total, 11* total timing, 150*+ IAT's, and low oil pressure due to grinding a couple main crank bearings. I went to a fully built LS2 a few weeks later. Never went back to the track. Truck was running decent. Here is the link to the video of that run and also the dyno video of what kind of power it was making at the time. Not to bad but what do you expect for the very first awd turbo ls1:tup:
1/4 mile run:
http://www.streetfire.net/video/project-insanity-the-beast-hits-the-14-mile-tra_184450.htm
Dyno:
http://www.streetfire.net/video/project-insanity-1st-dyno-pull_176839.htm
Yes. Pulled right off the trailer, very first run down the track. Stock LQ9, 1 PSI launch, like 8 psi total, 11* total timing, 150*+ IAT's, and low oil pressure due to grinding a couple main crank bearings.
I went to a fully built LS2 a few weeks later. Never went back to the track. Truck was running decent. Here is the link to the video of that run and also the dyno video of what kind of power it was making at the time. Not to bad but what do you expect for the very first awd turbo ls1:tup:1/4 mile run:
http://www.streetfire.net/video/project-insanity-the-beast-hits-the-14-mile-tra_184450.htm
Dyno:
http://www.streetfire.net/video/project-insanity-1st-dyno-pull_176839.htm