Needed SyTy shop in NJ/NY
- Thread starter rick1611
- Start date
BigBadSmoosh
Picking fights on I-65 since 2013
Re: Needed SyTy shop in NJ/NY
I have lots of friends in nutley, haven't seen any sy/tys in the area.. as for a shop to swap the turbo, is it a stock turbo?
rick1611 said:
I have lots of friends in nutley, haven't seen any sy/tys in the area.. as for a shop to swap the turbo, is it a stock turbo?
Captain Morgan
Moderated User
Re: Needed SyTy shop in NJ/NY
I could do it for you if you wanted to roll down to south jersey.
I could do it for you if you wanted to roll down to south jersey.
Xtrempickup
All turbo All the time
Re: Needed SyTy shop in NJ/NY
im about 10 min from you in garfield, i know somebody who is a local shop thats averse in turbos and we both own them and could do it for you for basic cost of shop time and anything that comes up needing repalcement
im about 10 min from you in garfield, i know somebody who is a local shop thats averse in turbos and we both own them and could do it for you for basic cost of shop time and anything that comes up needing repalcement
Last edited:
Re: Needed SyTy shop in NJ/NY
nutley.... hmm... right near the bullet hole shooting range in belleville.....and theres a local shop 10 minutes away from there.... are they just turbos/engine work? or do they do trans' as well...
Might have my engine rebuilt there... hmm they any good?
nutley.... hmm... right near the bullet hole shooting range in belleville.....and theres a local shop 10 minutes away from there.... are they just turbos/engine work? or do they do trans' as well...
Might have my engine rebuilt there... hmm they any good?
Xtrempickup
All turbo All the time
Re: Needed SyTy shop in NJ/NY
who you talking to gauge
who you talking to gauge
BigBadSmoosh
Picking fights on I-65 since 2013
Re: Needed SyTy shop in NJ/NY
i wish i could suggest someone local.. but i don't know any decent shops myself.
gaugeprower said:
i wish i could suggest someone local.. but i don't know any decent shops myself.
BigBadSmoosh
Picking fights on I-65 since 2013
Re: Needed SyTy shop in NJ/NY
same here, i could do it, just don't have the time.
leadfoot said:
same here, i could do it, just don't have the time.
ViciousV6
400HP/550FTLB
Re: Needed SyTy shop in NJ/NY
Motor built
www.simonekperformance.com
They have built mine twice, other than a crack in the crank after 2 years of driving, racing and beating on it in the low 11's. Now we got new motor and it could run 11.00 bracket racing with same turbo.
only Gt35R on it right now.
THey have built numerous supercharged, turbocharged engines, have dyno room, One of the builders runs an Quick 8 Turbo car went 6.99's
.
Ralph
ViciousV6
gaugeprower said:
Motor built
www.simonekperformance.com
They have built mine twice, other than a crack in the crank after 2 years of driving, racing and beating on it in the low 11's. Now we got new motor and it could run 11.00 bracket racing with same turbo.
only Gt35R on it right now.
THey have built numerous supercharged, turbocharged engines, have dyno room, One of the builders runs an Quick 8 Turbo car went 6.99's
.
Ralph
ViciousV6
Re: Needed SyTy shop in NJ/NY
My question was pointed here....
ViciousV6... I'm gunna check into the place you mentioned, sounds damn good to me... i'm pretty sure they'll do a better job than Dynotech did... I've heard horror stories...this engine lasted from 60,000 to ~90,000 ....a rebuild every 30,000mi is too short of a span for me....and I only drove it from ~80,000 - ~90,000
Xtrempickup said:
My question was pointed here....
ViciousV6... I'm gunna check into the place you mentioned, sounds damn good to me... i'm pretty sure they'll do a better job than Dynotech did... I've heard horror stories...this engine lasted from 60,000 to ~90,000 ....a rebuild every 30,000mi is too short of a span for me....and I only drove it from ~80,000 - ~90,000