MSBC Install

[protosy]

Anyone out there have any suggestions/pics/ideas for how to install a MSBC-1 boost controller?

I am looking for a place to locate it in the cab, that is clean, and relatively low key... Ease of wiring is also a big bonus. I hate running 8 million wires threw the firewall... would it be possible to locate the vacuum blocks in the cab and run a few vacuum lines out to the wastegate? or would that hurt the performance of it?

And while I am speaking about wires and crap, where does everyone run their wires threw the firewall to the engine compartment for gauges?

thanks guys.
chad

 

[gmcturbo]

i would try to keep the vaccume lines as short as possible. right above the pedals is a good place to drill a hole thru the firewall on these trucks.

 

[ghettosled]

keep the vacuum lines short and run extended wiring. The unit is obvisouly designed for race cars, so there is nowhere it looks subtle.. The glove box would be my suggestion. Take advantage of all the imputs though and use the launch stage as well as the manual stage imput. If you have any more questions just call or email me.