Leafs and Shocks

TheRock

New member
My Syclone has 109,000 miles and it is time for suspension work. I'm thinking on the Monomax's from TireRack with the lowering leafs from Summit. Good combination? Any other recommendations that won't cost a fortune?

Thanks,
Rocky
 

InvisiBill

Active member
I like my Edelbrock IAS shocks. But then again, those and the worn-out stockers are the only ones I've tried, and this is my only performance vehicle. *shrug*
 

TheRock

New member
Do the monomax work well with the drop from the BellTech springs?

Anyone have part numbers for the BellTech springs?
 

hideakimura

NipponSyTy
I installed Bell's leaf (P/N:5954) and Monomax on my truck.

It seems like the Monomax (normal height shocks) making my truck rear little higher if I compared my revious set up of 2' lowered block, but it might be normal height.

I guess the leaf and Bell's nitro setup should make it more lower and may make more softer setup, but it is only my guess from my experience on my previous truck.
Anyway I like my current setup.

leaf10.jpg


But I have another problem for the leaf and swaybar setup is coming up for next :(
 

kue

Member
I swapped the rear springs out on my ty last summer. I installed the belltech/KYB combo you are asking about. What I can tell you is that both rear shocks started to leak within a few months and need to be replaced. I am considering another set of KYBs since I apparently am the only one having problems with them (hoping that I just received a bad set)
 
Top