HELP!~ No power....

Syclone1639

Syclone1639

New member
Okay, I give up... Gotta stock Syclone with a check engine light on. Turbo gauge shows no boost but the turbo is spinning free. Removed the wastegate and everything looks fine. Replaced vac lines on the wastegate with new ones. When I accelerate I can't get much power. I have to slowly in crease in order to make speed. What are my options at this point? I'm gonna put it back together and get the code from a local shop. This is my daily driver so I wanna jump on it soon!~

Thanx SYTY Brotheran...
 
Osmosis

Osmosis

New member
Re: HELP!~ No power....

You need to fiugre a few things, SPARK< FUEL< AIR. How does she ilde and run at normal operations? Excessive fuel or oil consumption? How do the plugs look?

A few things you might want to check.
Plugs
Fuel pressure
Compression
As Chest Rockwell suggested, pull the code off the ECM.
You should also check your intake system for a air leak from the turbo to the engine. You can do a search for a thread that helps you troubble shoot leaks in the turbo to engine with the use of a bicycle tube and an aircompressor.

Keep us posted, it's always nice to see/hear one's results;)
 
92 Ty 1173

92 Ty 1173

Active member
Re: HELP!~ No power....

syclone809 said:
Vac line on map sensor
Click to expand...

Or even the MAP plug. When I got my red Ty the guy said the truck shut off going down the road and it would restart and idle but as soon as he tried to go it would sputter and stall. I got it, checked a couple things, found the clip was broken on the plug, taped it together and it runs fine now. Good luck.
 
You must log in or register to reply here.
Top