Gaskets needed for replacing turbo?
- Thread starter Eggr
- Start date
syclone809
Member
Re: Gaskets needed for replacing turbo?
There is no gasket that goes between the turbine housing and exhaust manifold. I'd port match the exhaust housing while you're there, you'll see the carbon buildup marks. A new oil drain gasket can be attained easily through ebay or some auto parts stores, as well as copper/aluminium crush washers for the water lines.
There is no gasket that goes between the turbine housing and exhaust manifold. I'd port match the exhaust housing while you're there, you'll see the carbon buildup marks. A new oil drain gasket can be attained easily through ebay or some auto parts stores, as well as copper/aluminium crush washers for the water lines.
Don W.
Stab it and steer it
Re: Gaskets needed for replacing turbo?
If they're the originals you should seriously consider changing the short hoses that connects the water lines. Especially the lower one. Which is fun. When you pull the lower one you will drain the block on that side. Lower one is really difficult but it beats loosing a motor. Might be easier if you remove the starter.
If they're the originals you should seriously consider changing the short hoses that connects the water lines. Especially the lower one. Which is fun. When you pull the lower one you will drain the block on that side. Lower one is really difficult but it beats loosing a motor. Might be easier if you remove the starter.