Front Crossover Brake Line
- Thread starter Syty84
- Start date
Sportmachines
Active member
Re: Front Crossover Brake Line
We have replacement line. In stailess. Whole set for a sy or ty is $195. If you only want that section, I will have to figure out the cost for just that piece.
We have replacement line. In stailess. Whole set for a sy or ty is $195. If you only want that section, I will have to figure out the cost for just that piece.
wheels
Donating Member
Re: Front Crossover Brake Line
I did this on my beater Blazer a couple weeks ago. I got a 60" (I think) piece of brake line with fittings and just used the old one as a template to make the new one. It was a bit long as you can tell by the pictures but it works. I left one end unbent until I fished it where it had to be then finished the bend to meet the fitting at the rubber hose. It might be a little more difficult on a SyTy with the lower I/C.
I did this on my beater Blazer a couple weeks ago. I got a 60" (I think) piece of brake line with fittings and just used the old one as a template to make the new one. It was a bit long as you can tell by the pictures but it works. I left one end unbent until I fished it where it had to be then finished the bend to meet the fitting at the rubber hose. It might be a little more difficult on a SyTy with the lower I/C.
Re: Front Crossover Brake Line
Where did you buy that line from, in store or online?
I did this on my beater Blazer a couple weeks ago. I got a 60" (I think) piece of brake line with fittings and just used the old one as a template to make the new one. It was a bit long as you can tell by the pictures but it works. I left one end unbent until I fished it where it had to be then finished the bend to meet the fitting at the rubber hose. It might be a little more difficult on a SyTy with the lower I/C.
Where did you buy that line from, in store or online?
wheels
Donating Member
Re: Front Crossover Brake Line
Local parts store. They should have varying lengths of straight line with fittings.
Local parts store. They should have varying lengths of straight line with fittings.