Recent content by turbodig

I've had reasonable luck with speed bleeders and an HF vacuum bleed kit. I think having someone pump the brakes manually would have been lots faster. Note - if you still have the ABS, you'll want to find someone with a Tech1 to run the ABS module through a bleed cycle. They get full of air on...

I had my quickest 60s on 15" Weld Alumastars with Hoosier stickies all around. Saved close to 20# per wheel/tire, if I remember right. Ripped off some low 1.50s with the stock unopened block and a 20g. Can't run 15s with bigger brakes, however.

Thanks for the tip on this - He had them, and they are excellent quality.

I want to say the intercooler was a powder coat of some kind, as was the upper intake. I've used alumablast myself on different things (brackets, etc), and it turned out well. Eastwood offers a 2k version of alumablast now in a rattle can, much tougher and fuel resistant.- Suit...

Is anybody still selling the emissions and belt-routing decals? I see some on ebay, but they look kinda questionable quality-wise. Will be painting the rad support soon and would like to have decals in hand before I attack it.

Thanks Dave... I figured it wasn't super critical. I gave it an extra shove from my 55... Should be close.

Anybody got the spec on these? Been through both the S10 manual and the Sy supplement, but I can't find a spec... I got 'em at 55 now.

Not sure you can even get a 14cm2 housing anymore if you tried, I've been looking for them for while? You could spool the 14cm2 housing up if you had the chip set up right or were using a custom boost controller. That said, it would certainly be a lot easier with a 12cm2 or 10cm2. Also, if...

Still 'around', whatever that means. I also shun social media, as there is just too much life outside of it. Anybody still on that was on the old mailing list, way back when? Extra points if you were on when I manually forwarded messages to everybody... :)

Will be in Madison area March 22-28...anybody up for beer and SyTy discussion?

Re: Build Folders - For Sale Sent for Sy 0689. Emailed information.

Re: 20G Turbo Info Please Mine ran 11.84 with an otherwise stock motor. It would also spool enough to be able to spin the tires hard through the 60-ft mark. And beat the crap out of the drivetrain. Of course, I had it tuned to do this. I also didn't do this with a bone stock converter. And...

Re: 20G Turbo Info Please Mine ran 11.84 with an otherwise stock motor. It would also spool enough to be able to spin the tires hard through the 60-ft mark. And beat the crap out of the drivetrain. Of course, I had it tuned to do this. I also didn't do this with a bone stock converter. And...

Re: Distributerless Ignition possiblity.. (working on it) It would be great if someone (Hint:sportmachines) would want to pick this up....

Re: BIG GUNS: What did you keep? Full stock motor (including injectors) ran 11.8x. Wish I would have stayed.