Search results

  1. The_Bronze

    AlkyControl Methanol Injection Kit

    I have a brand new, Still in the original packaging, Methanol/Alcohol Injection Kit for a GMC Syclone or Typhoon. Sold my truck and need to finish up selling the odds and ends that never got used. $525 shipped to the US.
  2. The_Bronze

    New Syclone Parts for sale

    Thanks!
  3. The_Bronze

    New Syclone Parts for sale

    Just have a few items left over. These are new in box parts, never installed. Torque Converter: 3K Stall 9/11 $550 Sold Tracking number sent! Upper intake manifold, ported and polished by RPM $300 Sold Tracking number sent! Alky Controls Methanol/Alcohol Injection System $475
  4. The_Bronze

    CO New, Unused Performance Parts for Sale

    Sorry for the delay. This part was spoken for and the deal was just finalized.
  5. The_Bronze

    CO New, Unused Performance Parts for Sale

    Stock heads, drilled for syty intake. 1.94 intake, 1.6 exhaust. Nothing fancy/no porting.
  6. The_Bronze

    CO New, Unused Performance Parts for Sale

    Added Prices. Going to start sticking these up on Ebay and Craigslist as well in the next few days!
  7. The_Bronze

    CO New, Unused Performance Parts for Sale

    Sold my Syclone to my brother and kept the performance parts I had acquired for it over the years. All the parts are new/unused. *Alky Control SYTY Methol/Alcohol System $500
  8. The_Bronze

    Almost a Ty owner!

    Re: Almost a Ty owner! When I worked in our I/M program office, quite a few of the newer ones got the tripometer written down in place of the odometer.
  9. The_Bronze

    Bringing her back...

    Re: Bringing her back... The other inside of the fender is prepped, drivers door and jamb are sanded as well. Now for the bottom of the hood, bed and rear of the cab. Just about ready for the first coat of primer!
  10. The_Bronze

    Bringing her back...

    Re: Bringing her back... Ambition is injected1 smoothing the firewall and removing the interior! I want to drive mine someday! ;)
  11. The_Bronze

    What did you do to your SY/TY today?

    Re: What did you do to your SY/TY today? While I wired my brother's early bronco for dual power supplies (1hot and 1 switched) so that I may power my WBO2 setup so that I can properly tune his carburetor, my brother welded in the 5 small patch panels into the bed of the Sy. We are going to fab...
  12. The_Bronze

    I had no intentions...

    Re: I had no intentions... My Sy has a salvage title. Bashed in the front sheetmetal and left the frame alone. I don't care and makes me actually feel good not to be modding a original, low mileage truck.
  13. The_Bronze

    Does your SyTy Run? POLL

    Re: Does your SyTy Run? POLL Frustrating to say it's still not running. The good news is that I am in the process of ordering up the performance upgrades.
  14. The_Bronze

    "S" in Syclone

    Re: "S" in Syclone I use and write the word "c"yclone in my everyday work. I constantly am fighting the spelling between the two. :roll:
  15. The_Bronze

    Syclone in Car Craft Magazine(Spectre 341 Challenge Feature)

    Re: Syclone in Car Craft Magazine(Spectre 341 Challenge Feature) It was nice to get some additional information on my screensaver. :D
  16. The_Bronze

    Code 32 - EGR Diagnostic Failure

    Re: Code 32 - EGR Diagnostic Failure I screwed that up. GM uses both MAP on EGR engagement and Fuel Trim change on disengement of EGR on non-OBDII vehicles. My alldata is broken and didn't verify in the manual before posting. Blanket apologies to all. In my own defense, fuel change is still...
  17. The_Bronze

    Code 32 - EGR Diagnostic Failure

    Re: Code 32 - EGR Diagnostic Failure Assuming you pressure washed the engine compartment (or even a garden hose): Remove the distributor cap and dry the insides well. I spray a bit of wd40 in the cap afterwards as well. If you didn't blow off a vacuum line or the electrical connector to the...
  18. The_Bronze

    weird accel problem...

    Re: weird accel problem... http://www.ttspowersystems.com/DataMaster.html
  19. The_Bronze

    bad idle

    Re: bad idle The PCM will see the throttle move via TPS and the MAP rise and energize the EGR solenoid briefly. If the EGR is okay, then it shuts immediately back off and EGR closes. If the valve is weak it can stay on even after the initial vacuum signal is removed from the valve and cause a...
Top