Recent content by quicksuv

Re: Transmission Differences Question i do a lot of 700s the only ouputshaft i ever seen broke was in my dads s10 89 4.3 but 4 low lanches is really tought on them

Re: how do i bleed the intercooler im replacing the intake gaskets and vac lines now im not running a cat and have 3in exh with a dynomax super turbo muffler

hello my name is josh i have a 93ty black anyone from west virginia

Re: Tranny rebuild 1600 is a good price for a built 700 there really strong if built right

my ty is setting an overboost code and cutting out a wot somebody told me i have a air pocket in the intercooler any body run into this

is mid 12 optimistic for stock turbo ty

is there any performance gain on a stock motor going to a 1.6 rocker arms

Re: chip info i hooked up an automeeter gauge it spikes at 15 and bleeds down to 12psi is that normal ? id has a vacume leak at the plenium im fixing now . its performs very well my goal is to keep the engine stock jst bolt ons id like to run mid 12s and remove the topspeed limiter

Re: stall speed recomendations cool mine bake stalls around 2000 did the vette make a noticable diffrence in yours i do a lot of 700 and 4l60e but ive only done one for a typhoon ive awys had good luck with vette converters in tpi and lt1 cars but the most ive ever seen one stall is 2200 ive...

Re: Tranny Pump remeber un bolt the lock up switch why are u replacing the pump

Re: Throttle TV Cable End dont worry anny tranny shop should have the end i keep those in stock u should have less than 5 dollars in it

the shaft move on my tb i have a good tpi off a 91 ta can u change the linkage to fit the typhoon i havnt looked real close at it yet

Re: Opinions on this tranny build a 700 can be built to hold up to a lot of punishment but it comes with a price my dad owns a transmission shop i have a little over 500 dollars in parts with out a converter a 200r4 is only for 2wd applications theres no way to make it a 4wd

Re: Controller preferences and reasons: PCS / TCI / TCI (old) it has 2 setting shift speed and firmness u it hass two screws to adjust for them

Re: intake gasket thanks