Recent content by hacaruso

No it won't slide in and out of the transfer case. I guess I'll have to drop the extension housing and see whats wrong.

Can anyone give me a measurement of how long the rear driveshaft should be? Thanks.

Yes the wedges are in place with the thicker part towards the rear. Can't figure out why it reaches with the blocks in but won't reach without them??

So the driveshaft is supposed to slide in and out of the transfer case a couple of inches? I can't get mine to budge and don't want to force it.

After taking out the 2" lowering blocks on my Syclone, the rear driveshaft will no longer reach the rear. Did they sell a shorter driveshaft with the lowering kit or is there another solution? I could always put the blocks back in but prefer not to.

re:jwaller re:jwaller Great! Here is my e-mail address: hanscaruso@comcast.net. Email me your address and I'll send your payment out tomorrow. Thanks for your help. Hans Caruso

Thanks for the info. If anyone has one of these pcv hoses laying around, please let me know and I will buy it in a heartbeat.

pcv part pcv part Actually I'm looking for the tee that comes out of the passengers side valve cover that holds both pcv valves. It has been discontinued from GM. Any ideas would help. I am also going to perform a compression leak down test Monday to see if I need pistons and rings. THanks Hans

I just bought Syclone #879 and need some help getting the pcv system back to spec. It seems someone modified the stock setup and I would like to get it back to stock. The drivers side valve cover used to have a hose that ran into the airbox but they put a breather on it instead. The problem I 'm...