11 sec setup, pte52.... SOLD

msheller

New member
FS: Barely used 11 sec setup...

(45K mile truck is fine, but must be returned to stock this month per customers request to return to collector status)

syty specific precision turbo and engine pte52 turbo barely used and its ceramic coated, new 50# injectors, new 3 bar map, phil long 50 # chip w/ 16 setting controller for pump versus race gas, msd 6al with easy connector, msd 2 step launch control, intake pipe for bigger turbo, 2800-3000 stall converter, Snow progressive controller alky, 3" pte downpipe(also ceramic coated) with dmh electric cutout, big fuel pump from 911 turbo but new

If you like to ease on the throttle and still smoke all 4 tires while pulling out(no foot brake), then this is the set up for you...unbelievably fun!!

parts cost almost $4,000 new, will sell for $1,800 obo PLUS exchange your GOOD stock parts (turbo, dp, injectors, 2 bar map, converter, intake pipe for stock turbo)
call matt at 518 365-0387....call me , We're not on email enuff to correspond reliably there....so please call instead.
 

TyGuyJeff

New member
Re: 11 sec setup, pte52....

Re: 11 sec setup, pte52....

Phone call made :)

I think I'm first in lin, boys :)
 

Silly

Banned
Re: 11 sec setup, pte52....

Re: 11 sec setup, pte52....

Phone call made :)

I think I'm first in lin, boys :)

Jeff hit me up when you can about this....pretty much the exact same setup I ran minus the chip.

Its a good deal!!
 

cloneman315

Active member
Re: 11 sec setup, pte52....

Re: 11 sec setup, pte52....

That chip that Phill was selling we actually made on my truck when it was stock on the dyno,the truck went high 11s on 22 to 24 psi,stock heads ,intake ic,etc etc,that is a great combo!!
 

2kwik4u

Resident slow guy
Re: 11 sec setup, pte52....

Re: 11 sec setup, pte52....

That chip that Phill was selling we actually made on my truck when it was stock on the dyno,the truck went high 11s on 22 to 24 psi,stock heads ,intake ic,etc etc,that is a great combo!!

How did he make a 50# chip for a PT52 setup with a mostly stock truck? I'm confused.
 

cloneman315

Active member
Re: 11 sec setup, pte52....

Re: 11 sec setup, pte52....

it was for 50# inj and a pte 52. not sure what you are asking?
 

2kwik4u

Resident slow guy
Re: 11 sec setup, pte52....

Re: 11 sec setup, pte52....

it was for 50# inj and a pte 52. not sure what you are asking?

You just said that it was made on your truck when it was stock on the dyno, in your first post. I didn't realize that your "stock" truck had 50lb injectors, PT52, and associated mods to make the chip accurate. I was just looking for some clarification, I'm straight now.
 

ZMann

vertically challenged
Re: 11 sec setup, pte52....

Re: 11 sec setup, pte52....

That sounds similar to my setup.... dang, send me a .bin! :)
 
Top